Unsupported or invalid g-code command found in block. Jog command with no '=' or contains prohibited g-code. (Grbl-Mega Only) Build info or startup line exceeded EEPROM line length limit. Safety door detected as opened and door state initiated. (Compile Option) Grbl '$' setting value exceeds the maximum step rate supported. Soft limits cannot be enabled without homing also enabled. G-code locked out during alarm or jog state. Grbl '$' command cannot be used unless Grbl is IDLE. Minimum step pulse time must be greater than 3usecĮEPROM read failed. Homing cycle is not enabled via settings. Negative value received for an expected positive value. Grbl '$' system command was not recognized or supported. Numeric value format is not valid or missing an expected value. G-code words consist of a letter and a value. Click on the missing item to return it to your workspace. LightBurn does a full disconnect / reconnect cycle when you right-click the Devices button, or when you click Ok from the devices menu.Ī common question is "Where did my Toolbar or Tool Window go?"Ī right click on any open area of a toolbar will bring up the options to turn on or off any toolbar or tool window. If you need to reset your device connection, from the Laser toolbox, right-click the Devices button. Machine Connectivity Reconnecting to a device
0 kommentar(er)
